![]() ![]() You will need to reconnect your devices if you had changed the password, or just change the password back to your preferred one. If that doesn't solve the problem, try forgetting and re-joining the Wi-Fi network or restarting your phone. ![]() On Android phones, you’ll know if there’s a Wi-Fi connectivity issue when the Failed to Obtain IP Address. This is why Wi-Fi network access is essential and a must-fix feature when it encounters problems on a mobile phone. DHCP is not enabled, so the Dell laptop will not be receiving an IP address. Nowadays, there is a need to stay connected online even when we’re on the go. But that cant possibly work, because the Hotspot on the P70 shows 'DHCP NO'. On the Dell laptop it already is showing IP Settings -> IP assignment -> automatic (DHCP). Make sure you use the wifi one for devices connecting to the wifi and the settings/admin one to access the Hub. What do I do if my phone is stuck in an 'obtaining IP address' loop Start by turning airplane mode on for a few seconds, then turning it off again. My Galaxy Nexus also refuses to get an IP address, but my Galaxy Tab 8.9 works fine. If yours is not on Automatic could you try with Automatic. The SSID’s will revert to that on the sticker too. Message: Your application was not able to obtain a license because the Flexnet license server manager could not determine where to find the licensing data it needs. I would be interested in seeing a screenshot of that 'protected by a PIN' message because I have never seen it. I couldn't get it to connect via wifi so did the initial sync via USB cable. ![]() Leave it 10' or so to stabilise and then your passwords/passphrase for both the Hub settings and the Wifi networks will revert to the two printed on the Hub sticker on its base/side/card. 1 I downloaded My Phone Explorer as I wanted a backup of all my Google data. With the Hub switched "on", disconnect any ethernet connections (leave the co-ax connected) and then push in the “reset pin” with the end of a paperclip/thin nail/SIM tray “tool” or similar (bigger items like ball point pen ends may not press it in far enough) until you feel it at the “stop point” and hold it there firmly for a "timed" minimum of 60 seconds do NOT manually restart the Hub at any time. Note that a pinhole reset on a Hub3/4/5 can be a bit problematic - so do it (again) EXACTLY this way (not as the VM website says!).įirstly, make sure the Hub's sticker/card with the two passwords on it is still there and legible If not – DON’T DO IT ! Try a pinhole reset again but done this way. Do all devices connected on ethernet cables connect fine to the network? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |